2004-10-30/2019-10-29 - From the OHS PC Database, derived from A Guide to North American Organbuilders, by David H. Fox (Richmond, Va.: Organ Historical Society, 1991). — Active in Hartford, Connecticut; makers of water motors, 1892-c. 1910. The water motor was a miniaturized, self-contained variation of the water mill. A pipe supplying water was attached on one side of a turbine case with an out flow pipe on the other. When the water supply was turned on, the turbine blades would spin, turning the central shaft which would turn a belt. Depending on the size of the motor, it could be used to power coffee grinders, drills, small lathes, or fans. The larger models were often used to power a blower for pipe organs before electricity became a reliable and readily available power source. —Ed. Source: Stopt Diapason #43 Newsletter (Hoffman Estates, IL: Chicago-Midwest Chapter of the Organ Historical Society).
Regrettably, it is not possible to display the information about the sponsor of this pipeorgandatabase entry or if there is a sponsor. Please see About Sponsors on Pipe Organ Database.